2 x ROTARY ROOF AIR VENTILATOR Whirly,Spinner,Trailer,Horse float,vent,white,PVC

$129.00 Buy It Now, FREE Shipping, 30-Day Returns, eBay Money Back Guarantee
Seller: daninwa2010 ✉️ (2,159) 98.8%, Location: Bunbury, WA, AU, Ships to: AU, Item: 226046497554 2 x ROTARY ROOF AIR VENTILATOR Whirly,Spinner,Trailer,Horse float,vent,white,PVC.

2 x ROOF AIR VENTILATORs – Rotary whirly/turbine type vents, white PVC plastic –for Van, Canopy, Caravan, Horse Float, Livestock, Bus, Truck, Motorhome

 

 

This is a highly economical type of wind-driven rotary roof ventilator – suitable for vans, trailers, trucks and all types of enclosed compartments. It is very low profile, waterproof and silent operating. It is made of durable PVC white plastic to not rust and to reflect heat. The main shaft and screws are long lasting stainless steel. The bearings are pre-packed with grease and are sealed both sides for long spinning life and to keep dust and water out which usually shortens the life of most rotary air vents.

 

This air vent has a twin-vaned air scoop design on top of it that starts spinning when an air-stream from natural wind or motion of the vehicle, activates it.  This spinning then creates air suction against 8 smaller air-vanes facing the opposite direction that are located at the base of this air ventilator (similar to how a turbocharger works).  Often these air vents will spin freely just from the forces of natural wind even when the vehicle it is parked and be ventilating without you driving.

 

 Remember, with this type of ventilator, the faster you drive the faster the air will be drawn out of the vehicle. So don’t be fooled into thinking you need an air vent with more external wind-vanes or one with a larger opening than this 100mm diameter opening air vent – unless the seller can tell you the exact air flow that occurs at any particular RPM.

 

 It is the design of the rotary vent and the speed that it is able to spin at while driving that determines the air flow. This air vent has one of the largest diameter external wind turbines to catch air (245mm diameter compared to 200mm of others) to spin faster. And it has a unique ‘air-flow-through’ wind-vane design that propels the wind-vane even faster upon exiting the rotary vent too ( see 2nd picture with arrows)

 

 

   

Installation is simple by first cutting a 100mm diameter hole in your roof (if requiring maximum ventillation). If you want less ventilation, then only drill a few 10mm to 25mm holes (within the 100mm diameter area) in your roof first instead. You can always drill bigger or more holes later for more ventilation.

 

To mount to your roof you will need to remove the centre bolt locknut with a 1/2” socket so that you can separate the stationary base plate from spinning air-vane. Then you will be able to drill 4 x 4.5mm holes to mount the circular base plate to your roof. Use pop rivets with washers behind them if riveting into thin metal or plastic. Or use shallow head bolts that do not stick up too far and stop the air vent spinning freely.

 

Note: this air vent is designed to deflect water or rain from entering through the air vent but you should seal the base of the air vent with silicone or sika-flex before installing on the vehicle  (make sure you look at all 12 pictures supplied here first)…

 

 

Installation instructions…

1.       Pull off cap on top of main centre bolt

2.       Remove the centre bolt locknut with a 1/2” socket

3.       Separate the circular base plate from the upper spinning air-vane

4.       Cut a 100mm diameter hole in your roof (or several smaller holes within 100mm circle)

5.       Position the circular base plate over the 100mm hole and drill the 4 mounting holes

6.       Seal the base with silicone or sika-flex and pop-rivet or bolt it on top (use large diameter washers behind the rivets or bolts if your roof is very thin for added strength)

7.       Re-install the spinning air-vane, locknut and cap

 

 

Overall Dimensions:

Diameter:                         245mm

Height:                             100mm (+ 20mm if including the small nut housing)

Roof hole diameter:        100mm

Base plate diameter:      140mm

 

 Benefits of this type of air vent
  • Very easy to Install
  • Draws heat out from inside of vehicle
  • Removes stale air, leaky gases and toxic odours from vehicles
  • Cool in summer and less draught in winter than other types
  • Spins silently unlike electric motor ventilators

  Note: if you want to shut off the air flow of these type of air ventilator then install 2 x inner vents that you can purchase from my e-store as well. Just see my other items for sale.
  • Condition: Brand New
  • Brand: Generic
  • Product Type: Air Vent

PicClick Insights - 2 x ROTARY ROOF AIR VENTILATOR Whirly,Spinner,Trailer,Horse float,vent,white,PVC PicClick Exclusive

  •  Popularity - 4 watchers, 0.3 new watchers per day, 14 days for sale on eBay. Very high amount watching. 4 sold, 10 available.
  •  Best Price -
  •  Seller - 2,159+ items sold. 1.2% negative feedback. Great seller with very good positive feedback and over 50 ratings.

People Also Loved PicClick Exclusive