Garrett Pro Pointer - Replacement Switch x 2 + Step by Step Fitting Instructions - Free UK Post
Does your Garrett Pro Pointer have a broken ON/OFF Switch - this EBAY listing is for the purchase of 2 x replacement switch plus full Step by Step fitting instructions.
Please Note: If you purchased your Garrett Pro Pointer less than 2 years ago then it is recommended that you contact either the shop you purchased it from or contact Garrett directly. A new pointer comes with 1 or 2 years warranty and therefore it will be best for any repairs to be made under warranty.
If your Pro Pointer is out of warranty and you wish to replace the Switch then we can offer the following service:
SUPPLY ONLY
We can supply a new switch to replace your current Pro Pointer switch. Included with the Switch are high level Step by Step instructions (written in English - however we will attempt to also supply instructions in other languages if required using Google Translate) to replace your switch.
To replace the Switch a soldering iron will be required (preferably one which also can remove solder from the existing switch) to remove the old switch and to solder the new switch in place.
It is not a very easy task and will require careful extraction of the circuit board, careful unsoldering/soldering and reinsertion of the circuit board. You should set aside 2 to 3 hours to perform this repair.
There is a purchase choice of 1 or 2 switches, we would recommend that you purchase 2 switches just in case you have a problem on your first attempt. Also, buying 2 switches within one order is cheaper than buying 2 separately .
NOTE: If you purchase this switch and later decide that you would prefer to have it installed for you, then please purchase our Repair service and we will refund your original payment (excluding the postage cost of sending the switch).